All Questions
Tagged with homemade-drone quadcopters
7 questions
0
votes
0
answers
26
views
What is the problem with my drone?
I am a newbie regarding drones. I created a drone using the following tutorial - drone link
The tutorial is about making a wall climbing drone but I ignored the climbing part of the drone. The drone ...
- 1
0
votes
0
answers
4
views
Eachine ts215 motors get hot
I bought a Eachine Wizard TS215 5' freestyle drone back in 2020 (now discontinued) that flew perfectly when I bought it. The PID tunning was already set from the factory and everything was running ...
0
votes
0
answers
21
views
Yaw angle estimation for quadcopters
I have built a quadcopter from scratch and I am at the stage of optimizing the roll, pitch, yaw angles estimation. To this end, I have implemented both Madgwick and Mahony AHRS filter and at the ...
- 111
0
votes
1
answer
97
views
Why are my motors not spinning at the same time although I calibrated them?
I'm currently working on a DIY project to make my own homemade Arduino based quadcopter drone. I have built the structure and have written the program. The drone consists of 1400KV motors, SimonK 30A ...
- 173
0
votes
1
answer
157
views
Which DC motors (or others) are good enough for my multi-function drone?
I am planning to make own drone which flies and dives (Some servo motors used to change between fly and dive-mode). But is a normal DC motor or a micro motor good enough (It flies and dives under tens ...
0
votes
1
answer
43
views
Claw using brushed ESC in conjunction with brushless ESC on Kakute H7
For a challenge, my club and I have been building a drone with a claw on the bottom. We found a good lightweight claw, but it uses an N20 Geared brushed motor. We have a brushed motor ESC(Quicrun 1625 ...
0
votes
1
answer
71
views
Why is my drone unable to fly?
I have made a drone using Arduino on my own, but unfortunately, it is unable to fly. What I mean by that is that the motors are working perfectly fine, but even after going above 70%, my drone is ...
- 173