Questions tagged [toy-grade-drone]
Use with questions asking specifically about drones that lack one or more features such that it has a substantial difference from hobby-grade drones.
10
questions
3
votes
2
answers
314
views
Which Arduino Nano should I use to make a nano-scale drone
Which Arduino nano is best for creating a nano drone?
Will it be compatible with 3.7 v coreless brushed motors?
- 381
3
votes
2
answers
206
views
Will wiring two batteries in parallel fry my drone?
Will connecting 2 lipo batteries of 3.7 V of 1500 mAh in parallel for a power source to a drone fry it? I understand the voltage will continue to be 3.7 V because it's in parallel. The current or Amps ...
- 381
2
votes
0
answers
48
views
Which drone kit is this
Which drone kit is shown here:
https://www.youtube.com/watch?v=QJOONKjX9xQ
What are your opinions of it?
R
- 381
4
votes
1
answer
72
views
Home made simple drone- need some directions
I made this small foam board frame.
I attached 4 motors after taking care that diagonally opposite motors rotate in same direction and adjacent ones in opposite direction. I ensure I wired the ...
- 381
2
votes
1
answer
53
views
Are all drone motors equal
I am now planning to buy a drone kit - A very light weight toy grade types. Know very little on this subject as of now.
Before doing that I have a few questions.
Can we assume that if there are four ...
- 381
3
votes
2
answers
38
views
Need tips on getting this to fly properly
Learning the basic concepts. Yet to use a receiver and remote. Using a 3.7 v coreless motor, lipo battery and thermocol for the frame.
I figured out how to connect the motors so that diagonally ...
- 381
3
votes
0
answers
34
views
What is the compatible drone frame for
I have four 3.7v coreless motors. The motors have a diameter of 7mm and length of 17 mm, with 45 mm propellers.
What is the compatible drone frame kit for this?
- 381
4
votes
2
answers
90
views
Lift off without receiver
Can I make a small drone frame achieve lift using 4 coreless 3.7 v motors of 55000 rpm, 3.7 v lipo batteries having 40c without a receiver and remote. Motors are all alike. The propellers I have are ...
- 381
5
votes
1
answer
242
views
Binding DX5e (or any other hobby controller) to generic "toy" drone - protocol compatability
I picked up a really cheap generic drone mostly for the purpose of tinkering and testing with something that I wouldn't mind losing or destroying. However I can't seem to bind to it with any of my ...
- 641
5
votes
2
answers
358
views
Can "toy" drone FC firmware be tweaked?
Can the flight controller of cheap "toy" grade quads, such as the Blade Inductrix, be programmed at all? I'd assume that even if it's possible, it wouldn't be practical. I don't have any ...
- 641