Unanswered Questions

152 questions with no upvoted or accepted answers
8 votes
1 answer
214 views

Recommended drone for 360 HDR sky photography?

Can someone please recommend a drone I could use for amateur 360 HDR sky photography in the USA? I hope recommendation requests like this are on-topic here. Requirements: I will be mounting a Ricoh ...
6 votes
1 answer
225 views

I need a low cost drone for point cloud modeling. What are the alternatives?

I am searching for a drone to work with point cloud modeling. The drone must have features such as orbital flying (flying around the subject with the camera always aimed to the center) while shooting ...
5 votes
1 answer
217 views

INAV beeps enabling NAVPOSHOLD?

I'm running a 500cm frame with 11" rotors. It flyes but the navigation modes seem to be a tip suprised, that INAV 3 seems to have some troubles, when I turn on the 3D GPS+baro position hold (...
5 votes
0 answers
84 views

Is VIO a good solution for autonomous drone navigation at higher altiutues (200+ms)?

When it comes in indoor scenarios, VIOs may provide good performance, but when it comes to outdoor environments and high altitudes without proper GPS coverage/stability, are current VIOs capable of ...
5 votes
0 answers
425 views

How can I update my flysky fs-i6?

I bought a flysky simulator cable but my computer running Windows 10 won't recognize the transmitter when I plug it in. I even tried it using Arduino UNO and a Windows 7 PC but didn't work either.
5 votes
0 answers
863 views

Remote controll via Mavlink with iNAV 3.0?

I'm not that familiar with Mavlink, but try to find a way to controll my FC Omnibus F4 nano v5 via a serial connection to a RPI (which is itself connect to a wifi). Using mavproxy, I'm able to ...
5 votes
0 answers
74 views

High pressure RC fuel pump

How many PSI do the best (electric) fuel pumps have? For RC jet turbines I found 12 bar the highest. Are there any better?
5 votes
0 answers
134 views

How can I see the coordinates of my vanilla DJI Mavic while flying?

What is the best way to get an older software version DJI Mavic to display GPS coordinates using the iPad? What about a new one? Is there a difference? If I can use something like Litchi to fly the ...
5 votes
0 answers
50 views

DJI Inspire 1 v2.0 Laptop Control

What are the options available to allow someone to control a DJI Inspire 1 v2.0 using an application installed on a Windows laptop? I know there are dongles available, but I'm not certain which are ...
5 votes
0 answers
679 views

Android Black-Box Viewer (Betaflight)

I'm using Speedy Bee (an Android betaflight configurator) a lot on the field for changing settings and tuning. I use a USB-OTG-Cable for my Android phone to connect to the FC. But I do miss an ...
4 votes
0 answers
65 views

Correct Flight Controller mixer settings for quadcopter with non-centred Centre of Gravity

I have a HobbyKing KK2.0 Flight Controller (FC) on a quadcopter. I have been trying to work out the correct mixer settings for a new H configuration I'm trying however the documentation isn't that ...
4 votes
0 answers
199 views

How to power a Companion Computer using the Holybro Pixhawk 4 Power Module (PM07)?

As the title says, I would like to power a companion computer (Raspberry Pi 3B in my case) using the PM07 Power Distribution Module: Power Module The Raspberry Pi should be powered via USB cable. ...
4 votes
2 answers
343 views

Brushless Motor not spinning when controlling with Raspberry Pi, PWM and ESC

I'm currently working on a drone which is controlled by a Raspberry Pi. I try to control the motors by using PWM on the connected ESCs, which is described in many guides and forums. For that I use the ...
4 votes
0 answers
84 views

Can I use an RX6R's PWM and SBus outputs simultaneously?

I'm looking at options to build a pan/tilt system for FPV. The FC that I have available has only 4 servo outputs, and the airplane has 3 servos. Given this, I can't run the pan and tilt through the FC....
4 votes
0 answers
160 views

How can I use XFLR5 in Ubuntu 20.04

I'm working on an aircraft project and I need XFLR5 to decide on a suitable airfoil. However, I can see that it is only available in Ubuntu 18.04. I'm using Ubuntu 20.04. What can I do about this? Is ...

15 30 50 per page
1
2 3 4 5
11