Questions tagged [wiring]
Use in questions regarding the proper way to connect electronic components of model aircraft or drones.
8
questions
0
votes
1
answer
31
views
Rewire drone motor
I am working on a new design that I need a motor to run independently without a computer. I essentially want to connect a drone motor that has three wires to a battery + and -. Does anyone know if ...
- 1
0
votes
1
answer
187
views
Can I use BAT and GND pads for wiring BetaFPV SMO4K?
I'm trying to wire BetaFPV SMO4K camera to my IFlight Evoque F5D which uses BLITZ F7 Stack (F7 V1.1 + 55A 4in1 ESC) stack. Official SMO4K manual suggests connecting camera power cable to ...
- 133
4
votes
0
answers
197
views
How to wire F4-FC-t-motor to FrSky-Xr602t-f2-D16 receiver
I have a t-motor F4 flight controller which I want to wire to a crossover Frsky D16-XR602T-F2 receiver. For power (5v) and ground, it is clear and it works. I connected the ...
- 141
7
votes
1
answer
777
views
Holy Stone HS110D Drone PCB Wiring - What does the circled wire in the picture do?
Total drone noob here so please bear with me. I bought my first cheap drone and I crashed it while flying indoor and one of the rotors stopped working so I took it apart to replace the rotor. But then ...
- 73
10
votes
3
answers
380
views
How do you build and use a smoke stopper?
What is the right way to build and use a "smoke stopper" device to prevent a short or other improper wiring from damaging your electronics?
Is it different depending on what voltage you are using?
- 1,130
4
votes
1
answer
714
views
Remap not yet existing uart
I have a flight controller that has one uart to little. So i tried to remap SERIAL_TX 5 (That doesn't exitst on the FC) to pin A09, that previously had SERIAL_TX 1, but that doesn't seem to work. I ...
- 2,654
5
votes
1
answer
1k
views
What is the analog video input pinout on the DJI FPV goggle?
I want to build an adapter cable for DJI FPV goggles analog video input. What is the correct connector type and the pinout for the analog signals?
- 215
8
votes
2
answers
440
views
Can I power the VTX and FC from the same vbat pad on the ESC?
I have the Hobbywing x-rotor 60A 4 in 1 ESC and the TBS Unify pro hv race.
Since neither my FC or ESC has a 10V regulator, I need to power both from the battery voltage. There is however only one ...
- 2,654