Questions tagged [imu]

For questions regarding the use of or configuration of an Inertial Measurement Unit.

Filter by
Sorted by
Tagged with
10
votes
2answers
286 views

Why is an MPU6000 more well suited for drones than an ICM IMU?

I have seen people say that the MPU6000 is the superior gyro chip, even though the ICM chip has a faster refresh rate and is technically superior in any other use. Why is it better to have a lower ...
8
votes
2answers
213 views

What does the full scale range in a IMU MPU9250 datasheet signify?

I have MPU9250 IMU, which I am working on to get orientations from the sensor output data. While exploring the MPU9250 (also other sensor such as BNO055) datasheet I came across the full scale range ...
7
votes
2answers
78 views

Difference between a 3 and 6 axis gyro

When shopping for drones, I see a 3 and 6 axis gyro available, what is the difference between the two? Does one have a advantage when flying over another?
6
votes
1answer
68 views

Why is the noise in my accelerometer more pronounced than the noise in my gyro?

I have a small quadcopter equipped with the MPU6050, which has a built-in accelerometer and gyroscope. It is able to sample the acceleration at 1 kHz and the angular velocities at 8 kHz. However, I ...
5
votes
1answer
89 views

Finding the velocity and position for small distance from IMU sensors

I am working on finding Velocity and Displacement from an IMU sensor (MPU9250). I have a Navio2 RPi4 setup, which gives me raw data (acceleration, Gyro, Magnetic). As per my research this can be done ...
5
votes
1answer
43 views

Eliminate effect of Vibrations on IMU

I am testing pitch orientation correction of Quadcopter and ended up in a issue. I have a test setup with one degree of freedom to test orientation correction. I have fixed the drone to the setup and ...
4
votes
0answers
22 views

What is the frame system defined for Orientations comptutation using Quaternions [Madgwick filter/ Mahony filter]?

I am working with MPU9250 and I have implemented attitude & heading reference system based on Madgwick/Mahony filter. I capture the raw data [accel, gyro, mag] and pass to the Madgwick filter in ...
1
vote
0answers
27 views

Is roll rate, pitch rate and yaw rate same as gyro data along y-axis, x-axis and z-axis

As per the title, I want to understand if the roll rate/pitch rate/yaw rate are same as the data obtained from mpu9250 gyro sensor along y-axis, x-axis and z-axis? If not then how to calculate roll ...