Questions tagged [crossfire]

Use on questions about the long-range RC system from Team Blacksheep operating within the 900 MHz frequency band.

Filter by
Sorted by
Tagged with
4
votes
2answers
28 views

Crossfire/Unify - Change Settings in TX and in OSD

I have a Crossfire Nano RX and a Unify Pro32 Nano VTX. I'm using the CRSF setting and wiring to allow the LUA script in the radio to change the settings in the VTX (power, band, channel, pitmode on/...
10
votes
1answer
51 views

Crossfire signal strength - comparing Immortal “L” vs “T”

Is there any detrimental effect on signal reception when mounting crossfire antennas in the Immortal "L" orientation compared to the traditional "T"?
10
votes
2answers
64 views

Should Crossfire transmitter antenna orientation match receiver antenna orientation?

I've always heard that you should orient the antenna on the Crossfire transmitter vertically, with the ends pointing up and down. I've also heard that you should do the same with the receiver antenna (...
8
votes
1answer
33 views

Crossfire, Unify VTX settings are being overwritten

I have a crossfire nano hooked up properly to a unify pro32 HV. Everything works as expected and perfectly except when I use the Crossfire Lite OSD to change the VTX settings. When I change the ...