0
$\begingroup$

i built a drone usiong multiwii controller and uncommented drone x and mpu6050 lines i calibrated the motors using it also but when i operate transmitter using multiwii software the software and drone is not recieving i even checked the connections and am stuck with this problem now. i am using _ arduino uno mpu 6050 flysky fsi6 and 1800 kv motors when i connect the battery noting happens but when i connet the board to computer the motors start rotating the software is properly responding to the gyro sensor but not transmitter

Improve this question
$\endgroup$

1 Answer 1

Reset to default
0
$\begingroup$

Turn off the ppm setting in transmitter

Improve this answer
$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.