It says jumper t16 is S-FHSS compatible. I put my Corona receiver into SBUS mode, but I can't get them to bind. Are the two compatible?
$\begingroup$
$\endgroup$
1
-
1$\begingroup$ I don't have this RX so I can't answer the question directly, but this is not an official S-FHSS licensed RX, likely the protocol was reverse engineered. The T16 module uses a reverse engineered protocol as well, so if they both made slight mistakes in their reverse-engineering, it is possible something is preventing them from binding correctly. The T16 seems to work fine with the offical Futaba S-FHSS recievers I have around otherwise. $\endgroup$– QuadMcFlyApr 15, 2020 at 12:49
Add a comment
|
2 Answers
$\begingroup$
$\endgroup$
1
I bought 2 of R6SF and both of them got bind to T16P V2. I actuary had same trouble with you, and bought another one. Both of them seem would not bind. Trying to update internal module firmware did not work out. But I finally did it with RF Freq. fine tune. It written on Jumper Website
$\begingroup$
$\endgroup$
There could be many reasons why it won't bind. Unfortunately, there doesn't seem to be a clear reason.
Did you follow the binding instructions in the Corona R6SF manual?
You might also try to upgrade the Jumper T16 internal multi-protocol module firmware. Here is a link to a video by Joshua Bardwell that outlines the process.
