0
$\begingroup$

I want to buy the „PDB-HEX, 12S“ Power Distribution Board. Are the current values of PDB/current sense resistor and ESC power pads meant for the summarized current of all motors or for each Motor? Why is the current sense resistor value higher than the esc power pads current?

PDB:

  • Input voltage range: 6~60V (2~12S LiPo)
  • PDB/current sense resistor: 140A cont, 264A burst.
  • ESC power pads: 60A cont. 100A burst
  • 6x ESC power /signal/ telemetry pads
  • Current Senor: 264A, 3.3V ADC
  • Current Scale 125(INAV/BF), BATT_AMP_PERVLT 80 (ArduPilot)

For Example:

I want to use this brushless motor with this specifications: enter image description here

When I use 4 of these motors I have a total max. current of 39.56*4=158.24A.

If the PCB-values "ESC power pads: 60A cont. 100A burst" are for a single pad it would fit but if it is for all motors it wouldn't fit.

Improve this question
$\endgroup$

1 Answer 1

Reset to default
0
$\begingroup$

I don't know the board, but current sensing is generally the total for all motors, which would explain why it's higher.

Current telemetry is usually used so you can gauge battery use, so you want the total.

The 'ESC power pad' figure is likely per-ESC as each ESC has its own set of pads. This limit is more than a quarter (or sixth) of the total because the highest loads occur when a motor is stalled by an obstruction, and that's rarely all motors at the same time.

Improve this answer
$\endgroup$
2
  • $\begingroup$ so the "ESC power pads: 60A cont. 100A burst"-value is for all 4 connections/motors in sum? $\endgroup$
    – dontoronto
    Mar 17, 2023 at 17:07
  • $\begingroup$ I edited the question for a better understanding. Thank you for your answer! $\endgroup$
    – dontoronto
    Mar 17, 2023 at 17:31

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.